• 0 users

    Following

  • 2 users

    Followed by

  • 81

    Subscriptions

  • Total activity 198
  • Last activity
  • Member since

Comments

Recent activity by Rosemary
  • It is like adding an edge loop, yes. (But not exactly, either.)  MD reworks the entire garment/pattern topology on the fly, whenever internal lines...

  • Best way would be to do a right-click on the desired seam(s), and choose Offset as internal line.  Then do a Fold angle on the internal line (and o...

  • Yes: what Angel has said. GPU is fast, but inaccurate.  CPU is accurate but slow.  You need to balance which of the two get used, and when, for the...

  • It is very likely that as you are using an imported avatar, that it is being brought into MD at the wrong scale.  MD works on a real-world scale, a...

  • Are you using an imported avatar?  What is the Height Measurement of that avatar? If an imported avatar is too small for the real-world scale that ...

  • Do a Cut-and-Sew to get a strip of cloth along the edge, if it isn't already a separate piece.  Lower the Particle Distance of that strip to 5 (or ...

  • Any time you see gathering folds like that, you need extra material in the perpendicular direction to the fold lines.  In this case, you need a tal...

  • Solidify will 'set' any wrinkles or creases and hold them through simulation.  Useful if you want to have a sweater or jacket sleeve pushed up an a...

  • You need to check the pattern:  a two-part collar looks more like this:The collar 'stand' is the part that sits 'vertically', as you describe it.  ...

  • Well, it doesn't seem like a huge difference between the two poses.  Your shirt does look loose enough to avoid the more common problem of a poor f...