A normal technique I use when making a collar, is cutting two pieces for each half of the collar. For each half of the collar, place the pieces right sides together and sew all edges except where the two halves of the collar will be joined. Then I would 'turn' each of the halves right side out through the open gap and press. This makes a very nicely finished edge. Sometimes I insert a short lace, or decorative edge trim between the layers when sewing right sides together. This technique works great on collars, belts, sashes..... My question is, "In Marvelous Designer, can we sew right sides together and turn?" or, "is there any need to do this"? In other words, will sewing the edges of the two pieces create a 'ditch' at the edge of the collar when sewing two wrong sides together? Discussion is appreciated.