Modify the Zipper Slider and Stopper (ver MD10) properties.
3D Toolbar ▶ Select/Move
Select the tool indicated in Location.
Select a Zipper or Stopper created on a 3D Garment and modify its properties:
Name the zipper.
Select a shape for the slider.
Select a shape for the puller.
Select the Stopper type (Open / Closed End) and then select shapes for Top and Bottom. (ver MD10)
※ Note: A selection of Bottom shapes is configured based on the shape of the Stopper.
Specification Gauge Select the size of the Slider by Gauge or percentage. Weight (g) Assign the weight of the slider. (ver 4.2) Fasten Zipper Reverse Zip Direction Select the zip direction. The slider is relocated based on the option. Move to Opposite Side Select a side of the zipper tape where the slider will locate when the zipper is open. Material Configure the Slider's Type, Texture, Color, and Opacity.
※ Note: Uncheck Use Same Material as Slider after selecting the Puller or Stopper tab to assign material separately. (ver MD10)
※ Note: Adjust the weight of the Slider